#Mac os disk utility cant see progress install#Also, I have no other drives attached at all while trying to do this High Sierra install on an SSD. Stuck.īy different controllers, I should have said I've tried most of the different SATA ports (not including the two Marvel ports, will try them later). But then putting it back into the High Sierra Installer setup, Disk Utility would again show it as "uninitialized". Erase the startup disk (Macintosh HD) using Disk Utility in macOS Recovery mode or a bootable installer drive (CD, DVD, or USB flash drive. Solution : The format challenge arises because the internal Mac startup disk is in use and won’t format. So, putting the SSD back into a 10.12 system, I could erase and rename it "High Sierra", thereby making it initialized. Sometimes, Disk Utility can’t erase the external disk due to some technical challenge. At that point the SSD would show up in the High Sierra Installer's Disk Utility, but only as an "uninitialized" disk, with no way to initialize it from within the High Sierra Disk Utility - it would keep saying "erase failed" due to not being able to read the drive's last block (or something to that effect). The little progress I did make was exactly what aol had suggested - that I format the SSD on a different mac running 10.12. But it runs Sierra 10.12.x flawlessly, for what that's worth.īy different controllers, I should have said I've tried each and every SATA port on the motherboard. Yes, I agree, this is an older motherboard (Z68MX-UD2H) and it's also running a legacy (nonEFI) F13 bios. ![]() Bad news is I'm not making a ton of progress. Building a CustoMac Hackintosh: Buyer's Guide
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |